Identify what is changing in Disk and washer volumes
Read the independent variable, dependent quantity, interval, and initial or boundary information before choosing an operation. Rebuild missing background in the calculus subject guide, then use calculus practice to retrieve the relationship without being told its name.
Conditions required before the rule can be used
The slice has to be a complete circle, so the cut must be perpendicular to the rotation axis and the region must reach that axis for a plain disk. When a gap separates the region from the axis you need the washer version, and when slices parallel to the axis are more natural, shells do the job better.
Build the derivative, integral, or model in stages
- Name the unknown, and the unit the answer has to come out in.
- Match the symbols to your values. $R$ is outer radius and $r$ inner radius.
- Check the conditions before substituting. $R\ge r\ge0$ and radii are perpendicular distances to the axis of rotation.
- Substitute, keep exact values to the last line, then test the sign, size, and unit against a rough estimate - The check that catches most calculus slips.
Disk and washer volumes through one changing case
Track what each line says about rate, accumulation, or evolution:
Check change against behavior and units
After using Disk and washer volumes, repeat the calculation with units attached and test the result against a boundary case or a quick numerical estimate.
Where a change calculation commonly breaks
What goes wrong: Squaring the difference of the two radii instead of subtracting the two squares.
Why it fails: Those are not the same quantity, and the difference-squared version removes far too much, so the reported volume is much too small.
Repair: Square each radius on its own, subtract, and then integrate the result.
Questions about change in Disk and washer volumes
How do I tell a disk problem from a washer problem?
Check whether the region touches the axis of rotation. If it does there is no hole and the inner radius is zero; a gap means a hole and a washer.
What if I rotate about a line such as y = 2?
Radii are measured from that line rather than from an axis, so each radius becomes a distance to y = 2. The rest of the setup is unchanged.
Why does this use π and not 2π?
Each slice is the face of a circle, whose area carries a single π. The 2π belongs to the shell method, where a slice is unrolled into a rectangle.
Should I integrate in x or in y?
Match the variable to the direction of slicing. Spinning around a horizontal axis gives slices of small width in x, and a vertical axis gives slices of small width in y.
Change one input, predict whether the output should rise, fall, or stay fixed, and only then recalculate.